Velocity Triggers Installation Guide

  1. Check to be sure the chamber of your firearm is empty.
  2. Dry Fire your weapon.
  3. Push out the rear take down pin and the front pivot pin
  4. Remove the upper off of the lower
  5. Using a 1/8” punch, push out the 2 trigger pins holding in your trigger assembly. Set them aside you will reuse them.
  6. Remove all old trigger parts
  7. Remove screw from inside grip. Remove grip (carefully) Don’t lose the spring and plunger pin held in by grip.
  8. Remove Safety
  9. Place Velocity Trigger in Lower, reuse trigger pins making sure they are centered.
  10. Reinstall Safety
  11. Using the provided Allen wrench, from the top of the Velocity Trigger, tighten the two 8/32 screws located to the left and right of the hammer in the aluminum trigger housing.
  12. Using the provided  8/32 x 1/8” set screws, install these in the same location as the first 8/32 screws tightened. These are locking screws and all work to prevent your pins from walking out.
  13. Reinstall spring, plunger pin, grip and screw
  14. Place your thumb in front of hammer (do not let the hammer hit the Lower) It may cause damage.
  15. Cock the hammer, TEST THE SAEFTY FUNCTION!!!
  16. Reinstall your upper.
  17. Congratulations, you have just made the greatest and easiest accuracy improvement to your rifle.